• It is a very easy material to apply.
• Water and gas impermeable.
• Resistant to chemicals and abrasion.
• Provides excellent adherence to concrete.
• Retouching Polymexbond-5060-Dilatation Tape Adhesive

EPDM BAND
High resistance to mechanical damage.
Dilatasyon hareket kabiliyeti, hem enine hem boyuna doğrultularda min. %250dir.
Excellent resistance to abrasion, aging and UV radiation
High flexibility in non-standard details
Excellent recovery of material after elongation

TZUS Certificate compliance : CSN EN 12 207 air tightness CSN EN 12 208 water resistant CSN EN 1026 wind load

Description Norm Classification
Tensile strength DIN 53 504 ≥ 6.5 Mpa
Elongation ≥ 250 %
Modulus 300 % DIN 53 504 ≥ 4.5 Mpa
UV Resistance DIN 53 504 Excellent
μ value 32 000
Sd value Thickness 1mm 22.4m
Dynamic puncture strength EN 12 691 Sealed, tight (10mm drill)
Static puncture strength EN 12 730 ≥ 250 N
Combustion class 4102 B2 B2
Heat resistance from -30 ºC to +150 ºC
Application temperature from +5 ºC to +35 ºC
Storage temperature from +5 ºC to +25 ºC
Storage time No limit

Dimensional tolerances
Standard width tolerance ± 1mm for cutting dimensions
Thickness tolerance ± 10%

Surface Quality: The application surface must be dry and free from all kinds of dust, dirt, weak and loose particles, cement grout residues, oil and grease. The concrete substrate must be clean, sound and have sufficient compressive strength (at least 25 N/mm2) and tensile strength (pull-off) must be at least 1.5 N/mm2.

Surface Preparation: Masking tape is placed on both upper sides of the dilatation to ensure that the dilatation tape comes out smoothly and the epoxy does not spread around.

Mixing: After adding component B to component A, mix with a low speed electric mixer (max. 400 rpm) for 4-5 minutes until a homogeneous color is obtained.

Polymexbond Epoxy is applied on the right and left upper side of the dilatation at least 5 cm. Then it is adhered on the dilatation tape. It is seen that the epoxy comes out of the holes of the tape. The next day, a second coat is applied on the tape, slightly overflowing to the edges. It is recommended to make an inverted or straight omega (Q) in the middle of the dilatation so that the tape does not lose its elasticity immediately.

• Temperature +5^° It should not be applied if below C.
• Solvent free, thinner
• When mixing and applying, wear rubber gloves and safety goggles to protect your skin and eyes from exposure. Especially eyes should be carefully protected.
• If splashed into eyes, rinse with plenty of water for about 15 minutes and consult a doctor immediately.
• Any foreign substance, water added to the product
• Since the product will harden immediately when mixed in extremely hot weather, it should be mixed as much as it will be consumed.
• Spills and contamination on application equipment Polymex Cleaning Agent and Polymexbond-5060-Dilatation Tape Adhesive